05 Print Preparation

Step 1 :

Place the print surface on the platform, paying attention to aligning the corners.

 

Step 2 :

Click home to reset the printer.

 

Step 3 :

Click the leveling button to automatically level the print surface.

 

Step 4 :

Click on auto leveling and wait for a few minutes for auto leveling.

 

Step 5 :

After leveling, click the middle point among the 5 points on the left to move the print head to the center point of the platform.

 

Step 6 :

Fold A4 paper in half and push it under the nozzle.

 

Step 7 :

Push A4 paper back and forth, feel if there is resistance, fine-tune at the screen.

 

Step 8 :

Click two adjustment buttons to adjust the nozzle position up and down to make first layer stick to print surface.

 

Step 9 :

Adjust up and down until there is a little resistance to the paper pulling, just push the paper to bend

(note that it cannot be too tight so that the paper cannot be pulled at all).

 

Step 10 :

Click two adjustment buttons to adjust the nozzle position up and down to make first layer stick to print surface.

 

Step 11 :

Put in the filament spool, pay attention to the direction of the filament spool.

 

Step 12 :

The filament have a certain bending angle at the beginning, which is not easy to push into the extruder.Bend the filament by hand to make them straight at least 10cm long.

 

Step 13 :

Cut a sharp angle at the front end of filamment with diagonal pliers.