Nozzle Size 0.4 mm Build Volume 125 x 110 x 125 mm Printer Size 245 x 255 x 320 mm Layer Resolution 20-300 microns Slicer Software Rose3D / Cura / S3D Input AC 100-220V AC Travel Speed 300 mm/s Support Filaments PLA / TPU / PETG etc. Touchscreen 3.2 inch Build Plate Leveling Auto Leveling Platform PEI / flexible bed System Supported MacOS / Win7/8/10
ROSE GO PRINTER 500g Fliament 8G flash-Drive Spool holder Print surface Fliament guide tube Side cutter plier Power adapter Leveling paper
Step 1 : Importing model and slicing Step 2 : Exporting file to printer Step 3 : Bed leveling Step 4 : Printing model Step 5 : Finishing printing Step 6 : Completed! You have already known the basic process of 3D printing. Let's start step by step.
Step 1 : Cut away the two zip ties that are securing the extruder in place. Step 2 : Assemble the spool holder, hold both ends with slight force, align the hole position, and insert the spool holder from the oblique bottom. Step 3 : Install the guide tube and insert the guide tube from the tube interface above the extruder. Step 4 : Insert the fastener into the gap under the tube interface to fasten the guide tube. Step 5 : Do the same for the connector at the nozzle.
Step 1 : Place the print surface on the platform, paying attention to aligning the corners. Step 2 : Click home to reset the printer. Step 3 : Click the leveling button to automatically level the print surface. Step 4 : Click on auto leveling and wait for a few minutes for auto leveling. Step 5 : After leveling, click the middle point among the 5 points on the left to move the print head to the center point of the platform. Step 6 : Fold A4 paper in half and push it under the...